1. Casing shall be manufactured with a threaded joint using a "V" thread on a thread pattern of 4 threads per inch on a 4 degree taper using 3 inches of threads.

2. Threaded joint shall be rated at maximum tensile strength according to wall thickness from tensile ratings chart and all joints must be pinned when total weight of casing string exceeds maximum rating.

3. Male and female threads are to be installed on casing in one process during manufacture of the casing joint.

4. Casing shall be manufactured in 20 foot lengths. 5 foot and 10 foot joints shall be manufactured by special order. Make-up in each threaded joint may vary by .250 inch.

5. Casing shall be tested and Certified to ANSI/NSF Standard 61 and labeled with the NSF mark on each joint.

6. Casing classification under ASTM D2996 is Type 1, Grade 2, Class A. This means casing shall be non-lined in standard product line.

7. Sand impregnated casing joint is recommended for use in cement grouted wells when borehole exceeds casing setting depth.

8. Casing shall be rated at maximum internal pressure rating according to wall thickness from internal pressure ratings chart. Joint must be taped with not less than 2 mils of Teflon tape and caulked with a Teflon based pipe dope to meet required values on joint.

9. All casing, 12 inch I.D. in diameter and larger, used in a cement grout application, shall be reinforced during manufacture by an outside corrugation of fiberglass that will substantially increase resistance to collapse.

10. Minimum wall thickness, of standard casing over 6.5" I.D., shall be .240" +- .020". All casing, to be cement grouted in a borehole, shall have a specific wall thickness along with outside fiberglass corrugations configured in accordance to Burgess Well Company specifications, according to depth of application and diameter of casing.

11. Maximum depth setting of all diameters of casing shall meet manufacturers setting recommendations.

12. All fittings, adapters and flanges, used in conjunction with Burgess fiberglass products, must conform with Burgess thread pattern, wall thickness and resin base to comply with manufacturers specifications.

13. All casing shall have an approximate ratio of 70% fiberglass to 30% resin by weight +- 5% as according to standard filament winding technology.

14. Angle (helix) of fiberglass to mandrel shall be 53 degrees +- 2 degrees during manufacture of casing according to standard filament winding technology.

15. Casing shall be sand coated for additional adhesion of cement grout as per engineers specifications.

---

All specifications and properties specified above are approximate. Specifications and properties of material delivered may vary slightly from those given above. Burgess Well Company makes no representations of fact regarding the material except those specified above. Final determination of the suitability of the material for the use contemplated is the sole responsibility of the Buyer. Burgess Well Company representatives will assist in developing procedures to fit individual requirements.


---

Burgess Well Company

724 East Highway 6, Minden, Nebraska, USA 68959-2569

Phone 308-832-1645 or 800-762-0331

Fax 308-832-0170 or 888-241-7580